Assessing the ability of potential evaporation formulations to capture the dynamics in evaporative demand within a changing climate

Rates of evaporative demand can be modelled using one of numerous formulations of potential evaporation. Physically, evaporative demand is driven by four key variables - net radiation, vapour pressure, wind speed, and air temperature - each of which have been changing across the globe over the past few decades. In this research we examine five formulations of potential evaporation, testing for how well each captures the dynamics in evaporative demand. We generated daily potential evaporation datasets for Australia, spanning 1981-2006, using the: (i) Penman; (ii) Priestley-Taylor; (iii) Morton point; (iv) Morton areal; and (v) Thornthwaite formulations. These represent a range in how many of the key driving variables are incorporated within modelling. The testing of these formulations was done by analysing the annual and seasonal trends in each against changes in precipitation (a proxy for actual evaporation), assuming that they should vary in an approximately inverse manner. The four-variable Penman formulation produced the most reasonable estimation of potential evaporation dynamics. An attribution analysis was performed using the Penman formulation to quantify the contribution of each input variable to overall trends in potential evaporation. Whilst changes in air temperature were found to produce a large increase in Penman potential evaporation rates, changes in the other key variables each reduced rates, resulting in an overall negative trend in Penman potential evaporation. This study highlights the need for spatially and temporally dynamic data describing all drivers of evaporative demand, especially projections of each driving variable when estimating the possible affects of climatic changes on evaporative demand. Crown Copyright (C) 2010 Published by Elsevier B.V. All rights reserved.