LES of the Slipstream of a Rotating Train

The slipstream of a high-speed train was investigated using large-eddy simulation (LES). The subgrid stresses were modeled using the standard Smagorinsky model. The train model consisted of a four-coach of a 1/25 scale of the ICE2 train. The model was attached to a 3.61 m diameter rotating rig. The LES was made at two Reynolds numbers of 77,000 and 94,000 based on the height of the train and its speed. Three different computational meshes were used in the simulations: course, medium and fine. The coarse, medium, and fine meshes consisted of 6x10(6), 10x10(6), and 15x10(6) nodes, respectively. The results of the fine mesh are in fairly agreement with the experimental data. Different flow regions were obtained using the LES: upstream region, nose region, boundary layer region, intercarriage gap region, tail region, and wake region. Localized velocity peak was obtained near the nose of the train. The maximum and minimum pressure values are also noticed near to the nose tip. Coherent structures were born at the nose and roof of the train. These structures were swept by the radial component of the velocity toward the outer side of the train. These structures extended for a long distance behind the train in the far wake flow. The intercarriage gaps and the underbody complexities, in the form of supporting cylinders, were shown to have large influences on the slipstream velocity. The results showed that the slipstream velocity is linearly proportional to the speed of the train in the range of our moderate Reynolds numbers. [DOI: 10.1115/1.4001447]