Related references
Note: Only part of the references are listed.Challenges and Opportunities in Direct Write Technology Using Nano-metal Particles
Kenneth N. Han et al.
KONA Powder and Particle Journal (2014)
Selective laser sintering/melting (SLS/SLM) of pure Al, Al-Mg, and Al-Si powders: Effect of processing conditions and powder properties
E. O. Olakanmi
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2013)
On the difference in material structure and fatigue properties of nylon specimens produced by injection molding and selective laser sintering
Brecht Van Hooreweder et al.
POLYMER TESTING (2013)
Metal Fabrication by Additive Manufacturing Using Laser and Electron Beam Melting Technologies
Lawrence E. Murr et al.
JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2012)
Microstructure and mechanical properties of open-cellular biomaterials prototypes for total knee replacement implants fabricated by electron beam melting
L. E. Murr et al.
JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS (2011)
Future direction of direct writing
Nam-Soo Kim et al.
JOURNAL OF APPLIED PHYSICS (2010)
Parametric appraisal of mechanical property of fused deposition modelling processed parts
Anoop Kumar Sood et al.
MATERIALS & DESIGN (2010)
The Hagen-Poiseuille pump for parallel fed-batch cultivations in microbioreactors
Michiel van Leeuwen et al.
CHEMICAL ENGINEERING SCIENCE (2009)
Ceramic components manufacturing by selective laser sintering
Ph. Bertrand et al.
APPLIED SURFACE SCIENCE (2007)
Thermal characteristics of a new metal/polymer material for FDM rapid prototyping process
SH Masood et al.
ASSEMBLY AUTOMATION (2005)
Development of new metal/polymer materials for rapid tooling using Fused deposition modelling
SH Masood et al.
MATERIALS & DESIGN (2004)
Mechanical characterization of parts fabricated using fused deposition modeling
A Bellini et al.
RAPID PROTOTYPING JOURNAL (2003)
Share Paper
