Related references
Note: Only part of the references are listed.An Introduction to System-Level, Steady-State and Transient Modeling and Optimization of High-Power-Density Thermoelectric Generator Devices Made of Segmented Thermoelectric Elements
D. T. Crane
JOURNAL OF ELECTRONIC MATERIALS (2011)
Maximum Power Point Tracking for Photovoltaic Optimization Using Ripple-Based Extremum Seeking Control
Steven L. Brunton et al.
IEEE TRANSACTIONS ON POWER ELECTRONICS (2010)
Model Building and Simulation of Thermoelectric Module Using Matlab/Simulink
Huan-Liang Tsai et al.
JOURNAL OF ELECTRONIC MATERIALS (2010)
Modeling a Thermoelectric Generator Applied to Diesel Automotive Heat Recovery
N. Espinosa et al.
JOURNAL OF ELECTRONIC MATERIALS (2010)
Thermoelectric automotive waste heat energy recovery using maximum power point tracking
Chuang Yu et al.
ENERGY CONVERSION AND MANAGEMENT (2009)
On the choice of dither in extremum seeking systems: A case study
Ying Tan et al.
AUTOMATICA (2008)
A numerical model for thermoelectric generator with the parallel-plate heat exchanger
Jianlin Yu et al.
JOURNAL OF POWER SOURCES (2007)
MPPT of photovoltaic systems using extremum-seeking control
R Leyva et al.
IEEE TRANSACTIONS ON AEROSPACE AND ELECTRONIC SYSTEMS (2006)
Optimization of cross flow heat exchangers for thermoelectric waste heat recovery
DT Crane et al.
ENERGY CONVERSION AND MANAGEMENT (2004)
Modelling heat exchangers for thermoelectric generators
J Esarte et al.
JOURNAL OF POWER SOURCES (2001)
Share Paper
