Confinement effect of stiffened and unstiffened concrete-filled stainless steel tubular stub columns

This paper presents a comparative study between stiffened and unstiffened concrete-filled stainless steel hollow tubular stub columns using the austenitic stainless steel grade EN 1.4301 (304). Finite element analysis of concrete-filled stainless steel unstiffened tubular stub columns is constructed herein based on the confined concrete model recently available in the literature. It is then compared with the experimental results ofconcrete-filled stainless steel stiffened tubular stub columns. The stiffened stainless steel tubular sections were fabricated by welding four lipped angles or two lipped channels at the lips. The longitudinal stiffener of the column plate was formed to avoid shrinkage of the concrete and to act as a continuous connector between the concrete core and the stainless steel tube. The behavior of the columns was investigated using two different nominal concrete cubic strengths of 30 and 60 MPa. The overall depth-to-width ratios (aspect ratio) varied from 1.0 to 1.8. The depth-to-plate thickness ratio of the tube sections varied from 60 to 90. The stiffened and unstiffened concrete-filled stainless steel tube specimens were subjected to uniform axial compression over the concrete and stainless steel tube to force the entire section to undergo the same deformations by blocking action. The ABAQUS 6.6 program, as a finite element package, is used in the current work. The results of the comparative study showed that the stainless steel tubes in stiffened concrete-filled columns offered a high average of increase in the confinement of the concrete core than that of the unstiffened concrete-filled columns. (C) 2009 Elsevier Ltd. All rights reserved.