Petrography, diagenesis and reservoir characteristics of the Pre-Cenomanian sandstone, Sheikh Attia area, East Central Sinai, Egypt

The diagenetic influence on reservoir characteristics was investigated for the Pre-Cenomanian (Early Paleozoic and Early Cretaceous) sandstone sequence in the Sheikh Attia area, East Central Sinai. This sequence can be distinguished into four formations: Sarabit El-Khadim Formation (Cambrian) at the base, Abu Hamata Formation (Cambro-Ordovician), Adedia Formation (Ordovician-Silurian) and Malha Formation (Early Cretaceous) on the top. The sandstones of Pre-Cenomanian sequence in the Sheikh Attia area are dominantly quartz arenites and subarkoses, where the quartz grains constitute about 82.3-98.4% of the framework composition with an average value of approximately 94% of the framework composition. Feldspars range in abundance from 0% to14.2%, with an average value of about 3% of the framework composition. The rock fragments constitute up to 9.8% of volume percent of framework grains, with an average of about 2.7%. Diagenetic events identified in these sandstones include compaction, cementation by calcite, quartz, clay minerals and iron oxides, dissolution and alteration of unstable clastic grains, and tectonically induced grain fracturing. Unstable clastic grains like feldspars suffered considerable alteration to kaolinite. The Pre-Cenomanian (Early Paleozoic and Early Cretaceous) sandstones possess good reservoir characteristics because they retain sufficient porosity and permeability in some intervals. These sandstones are characterized by porosity ranges between 3.80% and 27.60%, and have a permeability range from k <= 0.03 mD, for tight sandstones to k >= 50 mD, for the more permeable parts. The Pre-Cenomanian sandstones can be classified into four petrophysical flow units (megaport, macroport, mesoport and microport) with varying reservoir performances and are distinguished by comparable ranges of R35. Petrographic observations showed that the Early Paleozoic sandstones are texturally immature owing to the abundance of angular grains, non-uniformity of grain size, high amounts of matrix clay mineral, and high amounts of feldspar grains. The Early Cretaceous sandstones have low amounts of rock fragments, clay minerals, and feldspars grains. Statistical analysis of the petrophysical data confirms that the reservoir quality of Early Cretaceous sandstone is higher than that of Early Paleozoic sandstones (the reservoir quality index of Early Cretaceous sandstone is 0.383 mu m and for Early Paleozoic sandstones is 0.205 mu.m). (C) 2014 Elsevier Ltd. All rights reserved.