4.7 Article

The selection of appropriate spectrally bright pseudo-invariant ground targets for use in empirical line calibration of SPOT satellite imagery

Journal

Publisher

ELSEVIER
DOI: 10.1016/j.isprsjprs.2011.02.003

Keywords

Calibration; SPOT; Radiometric; Multispectral; Close range

Funding

  1. Academy of Finland, Department of Geosciences and Geography of the University of Helsinki

Ask authors/readers for more resources

The appropriate utilization of multi-temporal SPOT multispectral satellite imagery in quantitative remote sensing studies requires the removal of atmospheric effects. One widely used and potentially very accurate way of achieving absolute atmospheric correction is the calibration of at-satellite radiance data to field measures of the surface reflectance factor (rho(s)). There are a number of variations in this technique, which are known collectively as empirical line (EL) approaches. However, the successful application of an EL spectral calibration requires the presence and careful selection of appropriate pseudo-invariant ground targets within each scene area. Real surfaces, even those that are man-made and vegetation-free, display non-Lambertian reflectance behaviour to some extent. Because of the 31 off-nadir incidence angle range of the SPOT sensors, this is a crucial consideration. In favourable circumstances, it may be possible to utilize a goniometer to collect multiangular rho(s) measurements, but for widespread lower cost application of EL approaches currently, the use of a handheld spectrometer to measure nadir only rho(s) is a more realistic proposition. In either case, the selection of targets that have more limited and stable multiangular reflectance behaviour is preferable. Details are given of the reflectance properties of a variety of spectrally bright potential calibration surface types, encompassing sands, gravel, asphalts, and managed and artificial grass turf surfaces, measured in the field using the Finnish Geodetic Institute Field Goniospectrometer (FIGIFIGO). Bright calibration site selection requirements for SPOT data are discussed and the physical mechanisms behind the varying reflectance characteristics of the surfaces are considered. The most desirable properties for useful calibration targets are identified. The results of this study will assist other workers in the identification of likely suitable EL calibration sites for medium and high resolution optical satellite data, and therefore help optimize efforts in the time consuming and costly process of measuring p, in the field. 2011 International Society for Photogrammetry and Remote Sensing, Inc. (ISPRS). Published by Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available