Related references
Note: Only part of the references are listed.A Study on the Warpage of Glass Fiber Reinforced Plastics for Part Design and Operation Condition: Part 2. Crystalline Plastics
Min Lee et al.
POLYMER-KOREA (2012)
Effect of fibre orientation on the fatigue behaviour of a short glass fibre reinforced polyamide-6
A. Bernasconi et al.
INTERNATIONAL JOURNAL OF FATIGUE (2007)
A study of the mechanical behaviour of a glass fibre reinforced polyamide 6,6:: Experimental investigation
B. Mouhmid et al.
POLYMER TESTING (2006)
Experimental investigation of the effect of glass fibres on the mechanical properties of polypropylene (PP) and polyamide 6 (PA6) plastics
A Gullu et al.
MATERIALS & DESIGN (2006)
X-ray computed microtomography of internal damage in fiber reinforced polymer matrix composites
PJ Schilling et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2005)
A non-linear damage model for the tensile behavior of an injection molded short E-glass fiber reinforced polyamide-6,6
YX Zhou et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
Direct observation and measurement of fiber architecture in short fiber-polymer composite foam through micro-CT imaging
HB Shen et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2004)
Numerical simulation of three-dimensional fiber orientation in injection molding including fountain flow effect
KH Han et al.
POLYMER COMPOSITES (2002)
Automated reconstruction of curvilinear fibres from 3D datasets acquired by X-ray microtomography
CN Eberhardt et al.
JOURNAL OF MICROSCOPY-OXFORD (2002)
Share Paper
