Related references
Note: Only part of the references are listed.Effect of cutting parameters on the degree of work hardening and tool life during high-speed machining of Inconel 718
Dinesh G. Thakur et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
Effect of cutting parameters in the surface residual stresses generated by turning in AISI 4340 steel
Virginia Garcia Navas et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2012)
Residual stresses under quasi-static and cyclic loading in shot peened Inconel 718
Juergen Hoffmeister et al.
INTERNATIONAL JOURNAL OF MATERIALS RESEARCH (2012)
Surface integrity in material removal processes: Recent advances
I. S. Jawahir et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2011)
Machinability investigation of Inconel 718 in high-speed turning
D. G. Thakur et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2009)
RESIDUAL STRESSES ON INCONEL 718 TURBINE SHAFT SAMPLES AFTER TURNING
T. Berruti et al.
MACHINING SCIENCE AND TECHNOLOGY (2009)
SURFACE INTEGRITY CHARACTERIZATION AND PREDICTION IN MACHINING OF HARDENED AND DIFFICULT-TO-MACHINE ALLOYS: A STATE-OF-ART RESEARCH REVIEW AND ANALYSIS
Y. B. Guo et al.
MACHINING SCIENCE AND TECHNOLOGY (2009)
Analysis of residual stresses induced by dry turning of difficult-to-machine materials
J. C. Outeiro et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2008)
Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718
R. S. Pawade et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2008)
An analysis of the residual stresses generated in Inconel 718™ when turning
ARC Sharman et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Some effects of cutting edge preparation and geometric modifications when turning INCONEL 718™ at high cutting speeds
RT Coelho et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2004)
Effect of tool nose radius and tool wear on residual stress distribution in hard turning of bearing steel
M Liu et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2004)
Residual stress and surface roughness when facing age hardened Inconel 718 with-CBN and ceramic cutting tools
RM Arunachalam et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2004)
Workpiece surface integrity and tool life issues when turning Inconel 718™ nickel based superalloy
ARC Sharman et al.
MACHINING SCIENCE AND TECHNOLOGY (2004)
Overview -: Residual stress part 1 -: Measurement techniques
PJ Withers et al.
MATERIALS SCIENCE AND TECHNOLOGY (2001)
Share Paper
