Related references
Note: Only part of the references are listed.Validation of an analytical model for grinding temperatures in surface grinding by cup wheel with numerical and experimental results
Xiaofeng Zhang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2013)
Modeling temperature of non-equidistant primary shear zone in metal cutting
Fangjuan Zhou et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2013)
Analytical modeling and experimental investigation of tool and workpiece temperatures for interrupted cutting 1045 steel by inverse heat conduction method
Fulin Jiang et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2013)
Study on Machining Distortion of Titanium Alloy Aircraft Monolithic Component by Finite Element Method and Experiment
Yong Yang et al.
ADVANCED SCIENCE LETTERS (2011)
Experimental investigation on simultaneous measurement of temperature distributions and radiative properties in an oil-fired tunnel furnace by radiation analysis
Chun Lou et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2011)
A comparative study on Johnson Cook, modified Zerilli-Armstrong and Arrhenius-type constitutive models to predict elevated temperature flow behaviour in modified 9Cr-1Mo steel
Dipti Samantaray et al.
COMPUTATIONAL MATERIALS SCIENCE (2009)
A new approach to cutting temperature prediction considering the diffusion layer in coated tools
Zhang Shijun et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2009)
Analysis and estimation of cutting-temperature distribution during end milling in relation to orthopedic surgery
Naohiko Sugita et al.
MEDICAL ENGINEERING & PHYSICS (2009)
Temperature fields in a chip during high-speed orthogonal cutting - An experimental investigation
G. Sutter et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2007)
Investigation of chip-back temperature during machining depending on cutting parameters
Ihsan Korkut et al.
MATERIALS & DESIGN (2007)
A review on high-speed machining of titanium alloys
M Rahman et al.
JSME INTERNATIONAL JOURNAL SERIES C-MECHANICAL SYSTEMS MACHINE ELEMENTS AND MANUFACTURING (2006)
A numerical model to determine temperature distribution in orthogonal metal cutting
Y Dogu et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Key improvements in the machining of difficult-to-cut aerospace superalloys
EO Ezugwu
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2005)
Analytical models based on composite layer for computation of tool-chip interface temperatures in machining steels with multilayer coated cutting tools
W Grzesik
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2005)
Estimation of tool wear in orthogonal cutting using the finite element analysis
YC Yen et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2004)
A finite element study of the effect of friction in orthogonal metal cutting
GQ Shi et al.
FINITE ELEMENTS IN ANALYSIS AND DESIGN (2002)
Material behaviour in conditions similar to metal cutting: flow stress in the primary shear zone
SPFC Jaspers et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2002)
Material behaviour in metal cutting: strains, strain rates and temperatures in chip formation
SPFC Jaspers et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2002)
Modeling the high strain rate behavior of titanium undergoing ballistic impact and penetration
HW Meyer et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2001)