Related references
Note: Only part of the references are listed.Distribution of unit forces on the tool edge rounding in the case of finishing turning
Borys Storch et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
CHMM for tool condition monitoring and remaining useful life prediction
Mei Wang et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
Prediction and experimental validation of micro-milling cutting forces of AISI H13 steel at hardness between 35 and 60 HRC
S. M. Afazov et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
Effect of cutting parameters on the degree of work hardening and tool life during high-speed machining of Inconel 718
Dinesh G. Thakur et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
Optimization of machining parameters in rotary EDM process by using the Taguchi method
E. Aliakbari et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
Numerical analysis of chip formation and shear localisation processes in machining the Ti-6Al-4V titanium alloy
M. Calamaz et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2011)
Approach to optimization of part machining service combination
Huibin Sun et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2011)
Finite element simulation of machining of Ti-6Al-4V alloy with thermodynamical constitutive equation
Fang Shao et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2010)
An FEM study on residual stresses induced by high-speed end-milling of hardened steel SKD11
J. L. Li et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
The influence of tool flank wear on residual stresses induced by milling aluminum alloy
Z. T. Tang et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
3D finite element analysis of tool wear in machining
A. Attanasio et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2008)
Modelling tool wear in cemented-carbide machining alloy 718
J. Lorentzon et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2008)
Finite element simulation of conventional and high speed machining of Ti6Al4V alloy
Domenico Umbrello
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2008)
Wear phenomenon in the hard steel machining using ceramic tools
W. Grzesik et al.
TRIBOLOGY INTERNATIONAL (2008)
Wear behavior in turning high hardness alloy steel by CBN tool
H. M. Lin et al.
WEAR (2008)
Finite element modeling the influence of edge roundness on the stress and temperature fields induced by high-speed machining
Tugrul Oezel et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2007)
Modelling of surface finish and tool flank wear in turning of AISI D2 steel with ceramic wiper inserts
Tugrul Ozel et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2007)
On the effectiveness of finite element simulation of orthogonal cutting with particular reference to temperature prediction
D. Umbrello et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2007)
Tool wear when turning hardened AISI 4340 with coated PCBN tools using finishing cutting conditions
Reginaldo T. Coelho et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2007)
Flow stress of AISI H13 die steel in hard machining
Hong Yan et al.
MATERIALS & DESIGN (2007)
2D FEM estimate of tool wear in turning operation
LJ Xie et al.
WEAR (2005)
Share Paper
