Related references
Note: Only part of the references are listed.Three-point bending fatigue behavior of WC-Co cemented carbides
Anhai Li et al.
MATERIALS & DESIGN (2013)
Experimental investigation on chip morphologies in high-speed dry milling of titanium alloy Ti-6Al-4V
Anhai Li et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
Progressive tool failure in high-speed dry milling of Ti-6Al-4V alloy with coated carbide tools
Anhai Li et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2012)
The performance of PCD tools in high-speed milling of Ti6Al4V
Gert Adriaan Oosthuizen et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2011)
Machined Surface Analysis in High-Speed Dry Milling of Ti-6Al-4V Alloy with Coated Carbide Inserts
Anhai Li et al.
ADVANCES IN ABRASIVE TECHNOLOGY XIV (2011)
Effectiveness of uncoated WC-Co and PCD inserts in end milling of titanium alloy-Ti-6Al-4V
A. K. M. Nurul Amin et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2007)
Finite element modeling of 3D turning of titanium
Rui Li et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2006)
An overview of the machinability of aeroengine alloys
EO Ezugwu et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2003)
Wear mechanismes of new tool materials for Ti-6Al-4V high performance machining
N Corduan et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2003)
Developments in applications of PCD tooling
PJ Heath
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2001)
Wear mechanisms of ultra-hard cutting tools materials
F Nabhani
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2001)
Evaluation of wear mechanisms of coated carbide tools when face milling titanium alloy
A Jawaid et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2000)
Share Paper
