Related references
Note: Only part of the references are listed.Experimental analysis of mechanisms related to white layer formation during hard turning of AISI 52100 bearing steel
D. Umbrello et al.
MATERIALS SCIENCE AND TECHNOLOGY (2012)
An experimental investigation of affected layers formed in grinding of AISI 52100 steel
Cong Mao et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2011)
Modeling of white layer formation under thermally dominant conditions in orthogonal machining of hardened AISI 52100 steel
Anand Ramesh et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2008)
White layer formation due to phase transformation in orthogonal machining of AISI 1045 annealed steel
Sangil Han et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
The influence of machining induced residual stress and phase transformation on the measurement of subsurface mechanical behavior using nanoindentation
AW Warren et al.
SURFACE & COATINGS TECHNOLOGY (2006)
An experimental investigation of work material microstructure effects on white layer formation in PCBN hard turning
G Poulachon et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2005)
Analysis of white layers formed in hard turning of AISI 52100 steel
A Ramesh et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
High bandwidth thermal microscopy of machining AISI 1045 steel
MA Davies et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2005)
Formation of white layers in steels by machining and their characteristics
S Akcan et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2002)
TEM study on the surface white layer in two turned hardened steels
J Barry et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2002)
Tool-wear mechanisms in hard turning with polycrystalline cubic boron nitride tools
G Poulachon et al.
WEAR (2001)