Related references
Note: Only part of the references are listed.3D printing of β-tricalcium phosphate ceramics
E. Vorndran et al.
DENTAL MATERIALS (2009)
Rapid prototyping of electrically conductive components using 3D printing technology
J. Czyzewski et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
Ink-jet printing of ceramic micro-pillar arrays
M. Lejeune et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2009)
Effect of particle size on three dimensional printed mesh structures
Kathy Lu et al.
POWDER TECHNOLOGY (2009)
Development of translucent and strong three dimensional printing models
J. Suwanprateeb et al.
RAPID PROTOTYPING JOURNAL (2009)
Experimental analysis of properties of materials for rapid prototyping
Ana Pilipovic et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2009)
Direct digital manufacturing of three-dimensional functionally graded material objects
W. K. Chiu et al.
COMPUTER-AIDED DESIGN (2008)
Direct inkjet printing of Si3N4:: Characterization of ink, green bodies and microstructure
B. Cappi et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2008)
3DP process for fine mesh structure printing
Kathy Lu et al.
POWDER TECHNOLOGY (2008)
A new method for printer calibration and contour accuracy manufacturing with 3D-print technology
Sebastian Stopp et al.
RAPID PROTOTYPING JOURNAL (2008)
Indirect fabrication of collagen scaffold based on inkjet printing technique
Wai-Yee Yeong et al.
RAPID PROTOTYPING JOURNAL (2006)
Investigating the achievable accuracy of three dimensional printing
D Dimitrov et al.
RAPID PROTOTYPING JOURNAL (2006)
Studies on preparation of ceramic inks and simulation of drop formation and spread in direct ceramic inkjet printing
N Ramakrishnan et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2005)
Three-dimensional printing of porous ceramic scaffolds for bone tissue engineering
H Seitz et al.
JOURNAL OF BIOMEDICAL MATERIALS RESEARCH PART B-APPLIED BIOMATERIALS (2005)
Rapid prototyping and tooling techniques: a review of applications for rapid investment casting
CM Cheah et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2005)
3D fine scale ceramic components formed by ink-jet prototyping process
R Noguera et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2005)
Improved surface finish in 3D printing using bimodal powder distribution
M Lanzetta et al.
RAPID PROTOTYPING JOURNAL (2003)
Three-dimensional simulations of the droplet formation during the inkjet printing process
TM Liou et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2002)
Scaffold development using 3D printing with a starch-based polymer
CXF Lam et al.
MATERIALS SCIENCE & ENGINEERING C-BIOMIMETIC AND SUPRAMOLECULAR SYSTEMS (2002)
Share Paper
