Related references
Note: Only part of the references are listed.A comparative experimental investigation of deep-hole micro-EDM drilling capability for cemented carbide (WC-Co) against austenitic stainless steel (SUS 304)
Muhammad Pervej Jahan et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2010)
A study on the fine-finish die-sinking micro-EDM of tungsten carbide using different electrode materials
M. P. Jahan et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
A study on the quality micro-hole machining of tungsten carbide by micro-EDM process using transistor and RC-type pulse generator
M. P. Jahan et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
Nanofinishing of hard materials using micro-electrodischarge machining
M. P. Jahan et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2009)
Material removal rate and electrode wear ratio study on the powder mixed electrical discharge machining of cobalt-bonded tungsten carbide
Kuang-Yuan Kung et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2009)
Technology and research developments in powder mixed electric discharge machining (PMEDM)
H. K. Kansal et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2007)
Surface and sub-surface quality of steel after EDM
P Bleys et al.
ADVANCED ENGINEERING MATERIALS (2006)
Fracture and fatigue behavior of electrical-discharge machined cemented carbides
B Casas et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2006)
Investigation into some surface characteristics of electrical discharge machined SKD-11 using powder-suspension dielectric oil
YF Tzeng et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2005)
The influence of generator actuation mode and process parameters on the performance of finish EDM of a tool steel
FL Amorim et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2005)
Improvement of surface finish on SKD steel using electro-discharge machining with aluminum and surfactant added dielectric
KL Wu et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2005)
Influence of silicon powder-mixed dielectric on conventional electrical discharge machining
P Pecas et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2003)
3D surface topography assessment of the effect of different electrolytes during electrochemical polishing of EDM surfaces
H Ramasawmy et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2002)
Study of the effect of machining parameters on the machining characteristics in electrical discharge machining of tungsten carbide
SH Lee et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2001)
Effects of powder characteristics on electrodischarge machining efficiency
YF Tzeng et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2001)
Study of added powder in kerosene for the micro-slit machining of titanium alloy using electro-discharge machining
HM Chow et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2000)