Related references
Note: Only part of the references are listed.Analysis of directional factors in milling: importance of multi-frequency calculation and of the inclusion of the effect of the helix angle
Mikel Zatarain et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2010)
Roughness modeling and optimization in CNC end milling using response surface method: effect of workpiece material variation
B. C. Routara et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2009)
Measurement of milling tool vibrations during cutting using laser vibrometry
Kourosh Tatar et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2008)
Cutting force model considering tool edge geometry for micro end milling process
Ik Soo Kang et al.
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2008)
Mathematical models for surface characterization of machining processes
Peter Maass et al.
MICROSYSTEM TECHNOLOGIES-MICRO-AND NANOSYSTEMS-INFORMATION STORAGE AND PROCESSING SYSTEMS (2008)
Development of a cutting tool condition monitoring system for high speed turning operation by vibration and strain analysis
H. Chelladurai et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2008)
Prediction of tool wear using regression and ANN models in end-milling operation
P. Palanisamy et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2008)
Influence of machining cycle of horizontal milling on the quality of cutting force measurement for the cutting tool wear monitoring
Mecheri Kious et al.
PRODUCTION ENGINEERING-RESEARCH AND DEVELOPMENT (2008)
Tool condition monitoring in an end-milling operation based on the vibration signal collected through a microcontroller-based data acquisition system
Julie Z. Zhang et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2008)
Modeling regenerative workpiece vibrations in five-axis milling
Klaus Weinert et al.
PRODUCTION ENGINEERING-RESEARCH AND DEVELOPMENT (2008)
Tool wear evaluation by vibration analysis during end milling of AISI D3 cold work tool steel with 35 HRC hardness
Sadettin Orhan et al.
NDT & E INTERNATIONAL (2007)
An experimental study of tool wear and cutting force variation in the end milling of Inconel 718 with coated carbide inserts
H. Z. Li et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Selection of optimum tool geometry and cutting conditions using a surface roughness prediction model for end milling
NSK Reddy et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2005)
Prediction of cutting forces in end milling of pockets
L Zhang et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2005)