Related references
Note: Only part of the references are listed.Examination of machining parameters on surface roughness in EDM of tool steel
M. Kiyak et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2007)
An investigation of ultrasonic-assisted electrical discharge machining in gas
Q. H. Zhang et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2006)
A finite element model of EDM based on the Joule effect
J Marafona et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2006)
Modeling of a single resistance capacitance pulse discharge in micro-electro discharge machining
S Dhanik et al.
JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME (2005)
Analysis of the influence of EDM parameters on surface quality, MRR and EW of WC-Co
I Puertas et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2004)
Comparison of measured and simulated crater morphology for EDM
HP Schulze et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2004)
Measurement of impulsive forces and crater formation in impulse discharge
T Tamura et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2004)
EDM simulation: finite element-based calculation of deformation, microstructure and residual stresses
S Das et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2003)
Thermal stresses due to electrical discharge machining
V Yadav et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2002)
An experimental study on electro-discharge machining and polishing of high strength copper-beryllium alloys
JC Rebelo et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2000)