Related references
Note: Only part of the references are listed.Optimization of Flow Direction to Minimize Particulate Fouling of Heat Exchangers
M. S. Abd-Elhady et al.
HEAT TRANSFER ENGINEERING (2009)
Influence of sintering on the growth rate of particulate fouling layers
M. S. Abd-Elhady et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2007)
Design of a novel, intensified heat exchanger for reduced fouling rates
D Bouris et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2005)
Particulate fouling in waste incinerators as influenced by the critical sticking velocity and layer porosity
MS Abd-Elhady et al.
ENERGY (2005)
Minimum gas speed in heat exchangers to avoid particulate fouling
MS Abd-Elhady et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2004)
Numerical evaluation of alternate tube configurations for particle deposition rate reduction in heat exchanger tube bundles
D Bouris et al.
INTERNATIONAL JOURNAL OF HEAT AND FLUID FLOW (2001)
The removal of deformed submicron particles from silicon wafers by spin rinse and megasonics
F Zhang et al.
JOURNAL OF ELECTRONIC MATERIALS (2000)
Share Paper
